User's Manual

4.11. Installing Memory Cards

The HANDY TERMINAL supports Micro Secure Digital (SD) memory cards up to 32GB. Sandisk,

Kingstone and ATP micro SD recommended

To access the Micro SD card slot and insert the card, proceed as follows:

1. Press the Power key to put the terminal in Suspend Mode; see Suspend Mode on paragraph

4.23.

2. Remove the battery door on the back of the unit.

3. Remove the battery and open

4. Insert the SD card with the label facing upward.

☞

NOTE:

To remove an installed SD card tap on the edge lightly to unlock the card; the card will pop out just enough

for you to grab its edge and pull it out.

5. Tap the Power key to resume operation.

6. To verify that the operating system recognizes the new memory card, open Windows Explorer

and navigate to My Device

Storage Card.

WARNING:

Follow proper ESD precautions to avoid damaging the SD. Proper ESD precautions include, but are

not limited to, working on an ESD mat and ensuring that the operator is properly grounded.

Do not force the card. If you feel resistance, remove the card, check the orientation, and reinsert it.

Do not use the Micro SD card slot for any other accessories.

It is highly recommended to lock the card holder even if the card is not present.

4.12. Right Side Panel Layout

Side Button

You can use the Programs Buttons option in the Control Panel to change the functionality of

the side buttons. Scan function is assigned by default (Scan button).

EarJack

3.5pi 4pole Jack. This connector supports Ear-Mic headset

Ear jack socket Scan button Power button