User Manual

• Transmitted Data
• Received Data
• Request to Send
• Clear to Send
☞NOTE: ActiveSync is not supported
Ethernet Port (Single Ethernet cradle only)
Using an Ethernet cable, you can connect the
device to facilitate Ethernet communication to and from the terminal. This equipment is for
use only. The communication wiring is limited to the inside of a building.
12.6. Powering the Single Slot
Device
The terminal requires DC 5V input for communication and battery charging; the power adapter on
the power cable converts the voltage from the power source to
from Pointmobile convert the voltage appropriately.
The same power cable that ships with eac
used to power the base. This cable contains a plug adapter
for each geography (US, UK, EU, etc.).
1. Attach the appropriate plug adapter to the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector into the DC power jack on the back panel. The base is now powered.
When a terminal is properly seated, the base powers the
battery pack, and launches ActiveSync (see ActiveSync Communication on pa
Pointmobile recommends that you leave the base connected to its power source at all times, so that
it is always ready to use.
12.7. Charging the Battery
The base powers the terminal and fully charges
battery.
59
ActiveSync is not supported over the serial port.
Ethernet cradle only)
Using an Ethernet cable, you can connect the Single Ethernet cradle to an Ethernet
device to facilitate Ethernet communication to and from the terminal. This equipment is for
use only. The communication wiring is limited to the inside of a building.
Single Slot Cradle or Single Ethernet Cradle
input for communication and battery charging; the power adapter on
the power cable converts the voltage from the power source to DC 5V. Only power adapter cables
convert the voltage appropriately.
The same power cable that ships with each terminal can be
used to power the base. This cable contains a plug adapter
for each geography (US, UK, EU, etc.).
1. Attach the appropriate plug adapter to the power adapter.
2. Plug the power cable into the power source.
connector into the DC power jack on the back panel. The base is now powered.
When a terminal is properly seated, the base powers the terminal, charges the terminal’s main
ActiveSync (see ActiveSync Communication on pa
recommends that you leave the base connected to its power source at all times, so that
Charging the Battery
The base powers the terminal and fully charges the battery pack in 5or 8 hours depending on the
Ethernet cradle to an Ethernet-compliant
device to facilitate Ethernet communication to and from the terminal. This equipment is for indoor
or Single Ethernet Cradle
input for communication and battery charging; the power adapter on
. Only power adapter cables
connector into the DC power jack on the back panel. The base is now powered.
terminal, charges the terminal’s main
ActiveSync (see ActiveSync Communication on paragraph 10.4).
recommends that you leave the base connected to its power source at all times, so that
hours depending on the