User Manual

PM40 RF terminals are in conformity with all essential requirements of the R&TTE Directive
(1999/5/EC).
This device is marked with
requirements specified in the R&TTE Directive, 1999/5/EC. The device is
throughout the European Community; PAN European Frequency Range: 2.402 ~ 2.480 GHz.
Restrictions for use in France are as follows:
• Indoor use: maximum power (EIRP*) of 100 mW for the entire 2.400 ~ 2.4835 GHz
• Outdoor use: Maximum power (EIRP*) of 100 mW for the 2.400 ~ 2.454 GHz band and
maximum power (EIRP*) of 10 mW for the 2.454 ~ 2.483 GHz band.
The CE mark on the device indicates that the system has been tested to and confirm with
the provisions noted within the 2004/108/EC Electromagnetic Compatibility Directive and the
2006/95/EC Low Voltage Directive
Pointmobile shall not be responsible for use of our product with equipment (i.e., power
supplies, personal computers, etc.) that is not CE marked and does not comply with the Low
Voltage Directive.
2.9. WWAN
In radio systems configured with mobile c
must be allowed by the spectrum authorities of the specific
place. Be absolutely sure that the system
spectrum requirements of the country.
to the frequencies set by the system and do not
shows the correspondence between
HSPA
HSPA, or Evolved High-Speed Packet Access, is a t
telecommunication. HSPA enhanc
higher speeds for the end user.
2.10. WEEE Compliance
Information for the user in accordance with the European Commission Directive
2012/19/EU of the European Parliament and of the Council of 4
Electrical and Electronic Equipment (WEEE)
This product has required the extraction and use of natural resources for its production. It may
contain hazardous substances that could impact health and the environment, if not properly
disposed. In order to avoid the dissemination of those substances in our environment and diminish
the pressure on the natural resources, we encourage you to reuse, recycle and recover
If the product is disposed according to the Directive, it will
to the environment and human health which otherwise could be caused by incorrect disposal
The product marked with crossed out wheeled bin must be disposed separately from
municipal waste.
For more detailed information about disposal,
regional waste administration.
10
RF terminals are in conformity with all essential requirements of the R&TTE Directive
0984 in accordance with the Class II product
requirements specified in the R&TTE Directive, 1999/5/EC. The device is
throughout the European Community; PAN European Frequency Range: 2.402 ~ 2.480 GHz.
Restrictions for use in France are as follows:
Indoor use: maximum power (EIRP*) of 100 mW for the entire 2.400 ~ 2.4835 GHz
Outdoor use: Maximum power (EIRP*) of 100 mW for the 2.400 ~ 2.454 GHz band and
maximum power (EIRP*) of 10 mW for the 2.454 ~ 2.483 GHz band.
The CE mark on the device indicates that the system has been tested to and confirm with
ithin the 2004/108/EC Electromagnetic Compatibility Directive and the
2006/95/EC Low Voltage Directive, 1999/5/EC (R&TTE), and 2011/65/EU (RoHS)
shall not be responsible for use of our product with equipment (i.e., power
puters, etc.) that is not CE marked and does not comply with the Low
In radio systems configured with mobile computers and access points, the
must be allowed by the spectrum authorities of the specific country in which the installation takes
place. Be absolutely sure that the system frequencies are correctly set to be compliant with t
country. The Radio modules used in this product automatically
the system and do not require any parameter settings
shows the correspondence between PM40 types and radio modules:
Speed Packet Access, is a technical standard for wireless,
enhances the widely used WCDMA (UMTS) based 3G networks with
WEEE Compliance
Information for the user in accordance with the European Commission Directive
12/19/EU of the European Parliament and of the Council of 4
Electrical and Electronic Equipment (WEEE)
This product has required the extraction and use of natural resources for its production. It may
contain hazardous substances that could impact health and the environment, if not properly
osed. In order to avoid the dissemination of those substances in our environment and diminish
the pressure on the natural resources, we encourage you to reuse, recycle and recover
If the product is disposed according to the Directive, it will avoid potentially negative consequences
to the environment and human health which otherwise could be caused by incorrect disposal
The product marked with crossed out wheeled bin must be disposed separately from
mation about disposal, reuse, and recycle system, contact your local or
RF terminals are in conformity with all essential requirements of the R&TTE Directive
in accordance with the Class II product
requirements specified in the R&TTE Directive, 1999/5/EC. The device is intended for use
throughout the European Community; PAN European Frequency Range: 2.402 ~ 2.480 GHz.
Indoor use: maximum power (EIRP*) of 100 mW for the entire 2.400 ~ 2.4835 GHz
Outdoor use: Maximum power (EIRP*) of 100 mW for the 2.400 ~ 2.454 GHz band and
maximum power (EIRP*) of 10 mW for the 2.454 ~ 2.483 GHz band.
The CE mark on the device indicates that the system has been tested to and confirm with
ithin the 2004/108/EC Electromagnetic Compatibility Directive and the
1999/5/EC (R&TTE), and 2011/65/EU (RoHS).
shall not be responsible for use of our product with equipment (i.e., power
puters, etc.) that is not CE marked and does not comply with the Low
frequencies to be used
country in which the installation takes
frequencies are correctly set to be compliant with the
The Radio modules used in this product automatically adapt
require any parameter settings .The TYPE field
echnical standard for wireless, broadband
based 3G networks with
Information for the user in accordance with the European Commission Directive
July 2012 on Waste
This product has required the extraction and use of natural resources for its production. It may
contain hazardous substances that could impact health and the environment, if not properly
osed. In order to avoid the dissemination of those substances in our environment and diminish
the pressure on the natural resources, we encourage you to reuse, recycle and recover the product.
avoid potentially negative consequences
to the environment and human health which otherwise could be caused by incorrect disposal.
The product marked with crossed out wheeled bin must be disposed separately from
reuse, and recycle system, contact your local or