User's Manual

23
TRIOPTIC CODE 39,
CODE 11,
DISCRETE 2 OF 5,
MSI,
GS1 DATABAR LIMITED,
UCC COUPON,
MATRIX 2 OF 5
CODE 93,
INTERLEAVED 2 OF 5
CODABAR,
GS1 DATABAR 14,
GS1 DATABAR EXPANDED,
CHINESE 2 OF 5,
KOREAN 3 OF 5
SE655
Symbologies
UPC A,
UPC E1,
EAN 13,
CODE 128,
ISBT 128,
TRIOPTIC CODE 39,
CODE 11,
DISCRETE 2 OF 5,
MSI,
GS1 DATABAR LIMITED,
UCC COUPON,
MATRIX 2 OF 5
UPC E,
EAN 8,
BOOKLAND EAN,
GS1 128(EAN 128),
CODE 39,
CODE 93,
INTERLEAVED 2 OF 5
CODABAR,
GS1 DATABAR 14,
GS1 DATABAR EXPANDED,
CHINESE 2 OF 5,
Decoding a Bar Code
1. Position the Bluetooth scanner over one of the Sample Bar Codes on paragraph 7.8.
A range of 4-10 inches (10-25 cm) from the bar code is recommended.
2. Project the aiming beam by pressing and holding the Scan key. The Scan LED lights red.
3. Center the aimer beam horizontally over the bar code and highlight all of the vertical bars of the
bar code. The aiming pattern is smaller when the terminal is held closer to the code and larger
when the terminal is held farther from the code. Symbologies with smaller bars or elements (mil
size) should be read closer to the unit whereas larger bars or elements (mil size) should be read
farther from the unit.
4. When the bar code is successfully decoded, the decode LED lights blue and the terminal beeps.
Sample Bar Code
You can use the following bar code to verify decoding:
Scanning Positions
The aiming beam must be aimed across the entire bar code to provide you with the best scanning
performance. The aiming pattern is smaller when the terminal is held closer to the code and larger
when the terminal is held farther from the code. Symbologies with smaller bars or elements (mil
size) should be read closer to the unit whereas larger bars or elements (mil size) should be read
farther from the unit.