User's Manual

15
USB Cable
The Micro USB Cable is used when communicating between the terminal and a host computer to
transfer data via the USB interface.
Battery Power
The battery works to prevent data loss when the terminal is used over long periods of time.
The battery must be charged to full capacity before using the BLUETOOTH SCANNER AC
Adaptor for the first time!
Charge the main battery pack with the Bluetooth scanner AC Adaptor for a minimum of 4 or 6
hours depending on your battery before initial use.
Resetting the Terminal
The device is reset when pressing the SCAN, UP, and DOWN Key at the same time, and press
The UP key for 1 second to turn it on.
Sleep Mode
Sleep Mode suspends terminal operation. The terminal appears to be “off” when in Sleep Mode. The
terminal is programmed to go into Sleep Mode automatically when inactive for a specified period of
time. You can set this time period in the “Sleep Timeout” menu.
PM3 Technical Specifications
Model
PM3
Operating System
Firmware
Processor
ATMEL SAM4S16C, 32-bit ARM® Cortex® -M4 RISC processor 120Mhz
Memory
1MB(PGM), 4MB Storage Flash, 128KB RAM
Storage Expansion
N/A
Display
Bright OLED/ 0.96 inch(21.74mm x 11.18mm Active Area)
Scan Engine
1D engine: SE-965HP, N4313
2D engine: SE4710
CCD: SE655
Keypad
3 keys [ 1 scan key, 2 menu Keys (Up & Down) ]
Audio
Built-in speaker
I/O
Full Speed USB v2.0(12Mbps) Client.
support USB Disk Mode & USB to Serial mode