User's Manual

User manual PM250
© All rights reserved.
Pointmobile 45
Section Option Description
Basic Scanning Trigger timeout (sec) Set scanner timeout time
Good read off Scanner will stop scanning after
good read.
Enable continuous scan Scanner will scan continuous
until if checked good read.
Rescan after (sec) Set rescan time if enabled
continuous scan
Keyboard wedge
If enable
Keyboard wedge - software
program that interfaces with
a computer to translate
data read by a device other
than a keyboard, such as a
magnetic strip or bar code
reader or other such
scanning device, into
keyboard data.
Enable Check to enable keyboard
wedge
Options:
“Type writing“;
“Copy & paste”
Select data input method
according software you use
Termination code Select the desired barcode end
method from the pull down list
Notifier Beep
If enabled – plays audio
sound
Volume Set sounds volume
Succeed Set sound to indicate good read
Fail Set sound to indicate bad read
LED Enable Enable visual scan indicators
Vibrator
If enabled
Succeed: Set devices vibration time after
good read
Fail: Set devices vibration time after
bad read.
Wedge Barcode ID Transmit Barcode ID Enable to transmit barcode ID
Label Prefix Enter labels prefix
Suffix Enter labels suffix
Filter Accept Set filter conditions to accept
Deny Set filter conditions to deny
Symbologies Select barcode types you want to read
Details Enable this code Tap/enable this checkbox to
enable the selected bar code
type.
Features Select the desired features you
wish to enable for that specific
bar code type.
Length Set the minimum and maximum
lengths from the pull-down lists.
If the numbers are the same,
acceptable bar codes will only
be that length. Not all types will
have this option enabled.
General Try with Current Setting This button is enabled only if
you make changes to the
current settings. 1. Tap the Try
with Current Setting button. 2.
Press the <Scan> key. 3. Check
the result. 4. If you wish to keep
the new current settings, select
the Commit Current Setting