User's Manual
Table Of Contents
- CHD FiVE
- 1. Batteries and Power
- 3. Configuring a PDA
- 3.1. Control panel
- 3.2. Stylus
- 3.3. Backlight
- 3.4. Bluetooth
- 3.5. Date and Time
- 3.6. Dialing
- 3.7. Display Configuration
- 3.8. Input Panel
- 3.9. Internet Settings
- 3.10. Keyboard
- 3.11. Network and dialup connections
- 3.12. Owner
- 3.13. Password
- 3.14. PC Connection
- 3.15. Power Configuration
- 3.16. Programm buttons
- 3.17. Regional settings
- 3.18. Scanner configure
- 3.19. Storage manager
- 3.20. System Properties
- 3.21. Terminal server client licences
- 3.22. Volume & sounds
CHD FiVE
Computer Hardware Design 6
Resuming
Use one of the following methods to resume (wake up the PDA):
• Press [ Power ] key to suspend or resume (wake up).
• Put the PDA into a dock or connect to data cabel.
When a battery pack completely discharges while the unit is in suspend mode,
the PDA remains suspended until the discharged battery is changed or PDA
is connected to charger.
1.3. BATTERY
The battery pack in the PDA is a Lithium Ion battery pack 3.7V, 2000 mAh.
1.4. BATTERY WARNINGS AND CAUTIONS
Prior to using the PDA for the first time, you MUST charge the battery pack.
The initial charging cycle for both the battery pack and back-up battery takes
approximately thirteen (13) hours. Subsequent charging cycles take four (4)
hours.
If you remove the battery pack or it completely discharges, there is a 2 hour
window in which to insert a charged battery pack before the backup battery
completely discharges. If your backup battery completely discharges, the
contents of the RAM memory will be lost. If your backup battery is less than
fully charged, there is proportionally smaller window of time available.
Use only the correct battery packs, charger, and dock supplied by a CHD or
CHD dealer. The use of other battery supplies can damage the PDA and void
your warranty. For the correct supplies for the CHD FIVE, please contact your
CHD reseller.
Lithium-ion Polymer battery packs can get hot, explode, ignite and/or cause
serious injury if exposed to abusive situations.
Follow the safety warnings listed below:
• Do not place the battery pack in fire or heat the battery.
• Do not install the battery pack backwards so the polarity is reversed.
• Do not connect the positive terminal and negative terminal of the
battery pack
to each other with any metal object (such as wire).
• Do not carry or store battery pack together with metal objects.
• Do not pierce the battery pack with nails, strike the battery with a
hammer, step
on the battery or otherwise subject it to strong impacts or shocks.
• Do not solder directly onto the battery pack.
• Do not expose battery pack to liquids, or allow the battery contacts to
get wet.
Do not disassemble or modify the battery pack. The battery pack contains
safety and protection devices, which, if damaged, may cause the battery pack
to generate heat, explode or ignite.