Quick start Guide-PLUS III

Using Auto-Relay

NOTE: Auto-Relay allows you to trigger remote ashes in sync with a remote camera and

requires only three PocketWizard

radios. Using Auto-Relay is the only situation where not

all PocketWizard radios are set to the same channel: The relaying radio trasmits on one

channel higher than it received on. Visit wiki.PocketWizard.com for additional information.

Auto-Relay

Plus

III

(Transmitting)

Channel 1

Remote Camera

(Relaying Plus III)

Receiving Ch.1 & Transmitting Ch.2

Remote Flash

(Receiving)

Channel 2

1. Set the transmitting PocketWizard radio in your hands to TxRx Mode and

the desired channel and zone.

2. Connect the relaying Plus III’s Flash/Camera Port to the remote camera

triggering port of the camera via a remote camera cable and place the

radio in the camera’s hot shoe.

Set the relaying Plus III attached to your remote camera to TxRx Mode and also to

the same channel and zone as the transmitting PocketWizard radio in your hands.

4. Connect a remote ash to a receiving PocketWizard radio via the appropri-

ate sync cable and set it to TxRx Mode and one channel higher than the

transmitting PocketWizard radio in your hands.

5. Press and release TEST on the transmitting PocketWizard to re the remote

camera. Remote ashes will be automatically synchronized with the camera.