Quick start Guide-PLUS III

Other Functions
Status LED
TEST Button (Two Stage Trigger)
Reset
USB
The Plus III’s status LED will blink in three different colors: Green, Red and Amber.
Green Blinking indicates good battery life.
Amber Blinking indicates the batteries are getting low or when TEST
button is half-pressed.
Red
Blinking indicates batteries are critically low and should be changed
immediately. The status LED turns solid red when Plus III is
transmitting or receiving a trigger.
Half-pressing
the TEST button on a transmitting Plus
®
III pre-releases
a remote camera connected to a receiving PocketWizard
®
radio with a
remote -ACC camera cable (available separately). This wakes up the cam-
era and makes it respond more quickly and consistently, but also reduces
battery life. Half-pressing the TEST button will not affect remote ashes.
See wiki.PocketWizard.com for more information.
Fully pressing
the TEST button res any remote cameras or ashes con-
nected to receiving PocketWizard radios set to the same channel and zones.
To reset your Plus III Transceiver to the default setting, hold the TEST button
as you power the radio on. The default mode after a reset is TxRx on
Channel 17 with all Zones enabled.
The Plus III can be powered via USB with a compatible AC adapter or from most
computers. Future rmware updates can be installed via the PocketWizard Utility.