Quick start Guide-PLUS III

Channels

Using Zones

The Plus

III Transceiver supports 32 different Standard Channels. Each Stan-

dard Channel represents a digital code transmitted on specic PocketWizard

radio frequencies. This enables many photographers to work in the same

area or for one photographer to exclusively control different sets of receivers.

A Plus III will trigger any number of receiving PocketWizard radios set to the

same channel. Radios set to different channels will not trigger each other.

Press the Channel Up/Channel Down Buttons

to change channels.

Features that use Zones are only available on channels 17-32.

Zones can be used to toggle remote cameras or ashes on or off from a

transmitting PocketWizard radio. Zones can also be used when sharing

ashes with another photographer so only some of the remote ashes are

shared, even when using the same channel.

Zones A, B, C, and D are selectable via the Plus III’s Zone Toggle Buttons

when using channels 17-32. The enabled Zones are displayed in a box on

the right side of the LCD. You can enable any combination of all four Zones.

A receiving Plus III will only trigger if the transmitting PocketWizard radio

has at least one matching zone enabled.

Quad-Zone Triggering on a transmitting or receiving Plus III can work with any

other PocketWizard radios that support Quad-Zone Triggering Channels 17-32.

Channels and Zones

NOTE: Some PocketWizard

radios, like the MiniTT1

or FlexTT5

, operate on Standard

Channels as well as ControlTL

Channels. ControlTL Channels work with TTL or remote

ash power control. This Plus III can work with any PocketWizard radio transmitting or

receiving on Standard Channels, but not ControlTL Channels.

English