Quick start Guide

Channels can be taught via PocketWizard Utility (recommended)
or from any PocketWizard transmitter:
IMPORTANT: Hold radios at least 2 feet apart when teaching/learning.
1. Turn MiniTT1 or FlexTT5 radio ON and select channel to be taught: C.1 or C.2.
2. Press and hold TEST for several seconds until LED blinks amber, then release TEST.
3. Quickly press and hold TEST on teaching transmitting radio (MiniTT1, FlexTT5, Plus II
or MultiMAX). When LED blinks green, channel is learned. Connected flash may
trigger during LEARN.
1 green blink = Low Standard channel learned (1 through 16, including Plus 1 through 4)
2 green blinks = High Standard channel learned (MultiMAX 17 through 32)
3 green blinks = ControlTL channel learned
For remote E-TTL systems, teach MiniTT1 radio to be used as primary transmitter first,
then use it to teach all FlexTT5 units.
MiniTT1 and FlexTT5 radios send out both ControlTL and Standard triggers every time
they are triggered. For remote E-TTL to function, ControlTL channel must be learned.
If you see only 1 or 2 green blinks, and you desire E-TTL, teach again with MiniTT1
or FlexTT5 radio. Look for 3 green blinks to verify ControlTL is learned.
To teach all radios Standard channels, use Standard transmitter as teaching radio for all
learning radios, including MiniTT1 radio to be used as primary transmitter.
To avoid inadvertent flashing from remote radios that have already been taught or
have already had channel set, turn them OFF.
LEARN Mode