Quick start Guide

Ratio Wireless E-TTL: MiniTT1 OO FlexTT5

Flash on Camera

1. Slide MiniTT1 Transmitter onto camera.

2. Slide Canon 580EX Speedlite onto MiniTT1 radio. Set Speedlite for MASTER = ON.

Enable slave groups/zones per ﬂash instructions. Canon Speedlite Transmitter ST-E2

may also be used.

3. Set remote FlexTT5 radio to desired Canon ratio slave group/zone (A, B, C) using

FlexTT5 zone switch.

4. Slide remote Speedlite onto FlexTT5 Transceiver. Set Speedlite for regular E-TTL mode

(not SLAVE or MASTER). Repeat for each remote Speedlite. All remote E-TTL ﬂashes on

same FlexTT5 slave group/zone will be treated as one zone of light.

5. Adjust ratios using MASTER Speedlite ﬂash controls.

6. Make sure all your PocketWizard radios are on the same channel and trigger normally.

IMPORTANT: Canon ﬂashes set to SLAVE = ON and connected to FlexTT5 radios will have

slave mode automatically turned off, but will still function as slaves correctly. Set desired

Canon slave group/zone via remote FlexTT5 zone switch. PocketWizard channel is used

instead of Canon channel.

ISO, aperture, ﬂash exposure compensation (FEC), and other settings will track exposure

normally via the PocketWizard ControlTL system.

E-TTL

English