Quick start Guide

Other Functions

RESET

RESET A: To reset learned channels to channels last set in Utility, hold TEST on power up.

LED blinks green twice to indicate reset. Release TEST. Advanced features set via

Utility are retained.

RESET B: To reset all advanced features and channels to FACTORY DEFAULTS, hold TEST on

power up for longer than 10 seconds. When LED blinks green 4 times, release.

B: Default Advanced Features

C.1 = ControlTL channel 1, Standard channel 1

C.2 = ControlTL channel 2, Standard channel 2

HyperSync Offset = -170 microseconds

High Speed Sync (FP Flash Sync) Disable Mode = not enabled

High Speed Sync (FP Flash Sync) Begins At = 1/400

Remote TTL Flash Sleep Mode = disabled

Basic Trigger Mode = disabled

Camera Model = Auto

Force TTL Master Mode = enabled

FlexTT5 Only:

Use ControlTL for Rx Channel = enabled

Flash Idle Time Out Mode = disabled

Transmitter Only Mode = disabled

Bottom Shoe Disable Mode = not enabled

All settings may be conﬁgured using the PocketWizard Utility available from www.PocketWizard.com