Quick start Guide

ControlTL
®
Center Point: The center point for all ControlTL operations, including Basic Power Control, PowerTracking, or
whenusinganAC3ZoneController,is3stopsdownfromyourash’smaximum.Forexample,inBasicPowerControlthis
means0onyourcamera’sFECequals1/8onyourashandFEC+3equals1/1(fullpower).Thissettingmaybe
customized using the PocketWizard Utility under the PowerTracking tab.
Camera FEC Range and Basic Power Control: You can change the center point to better match your camera’s FEC
range by adjusting the Flash Exposure Compensation control in the PocketWizard Utility for each PowerMC2.
ThissettingmustbeconguredoneachreceivingPowerMC2radio.
Camera FEC
Range
Maximum remote
Einstein
™
E640 power
level available using
default settings
Minimum remote
Einstein
™
E640 power
level available using
default settings
Set each
PowerMC2 FEC
so camera
maximum FEC
equals ash
maximum
output power
Set each
PowerMC2 FEC
so camera
minimum FEC
equals ash
minimum
output power
Canon +3 / -3
1/1 at FEC +3 1/64 at FEC -3 0 -2
Canon +2 / -2
1/2 at FEC +2 1/32 at FEC -2 +1 -3
Nikon +1 / -3
1/4 at FEC +1 1/64 at FEC -3 +2 -2