Quick start Guide

ControlTL allows you to adjust your remote studio ash’s output
power directly from the camera position in three ways:
Basic Power Control - With just a ControlTL transmitter on your camera, use your camera’s
FECtoadjustremoteashoutputpower.ThisiscalledPowerTracking - Full Manual and is
the default when you are not using an AC3 ZoneController on your ControlTL transmitter. See
the Basic Power Control section for more information.
Automatic PowerTracking - When engaged, any changes to aperture and ISO on your camera
areautomaticallytrackedbyyourremoteashoutputpowertomaintainthecurrentexposure
level. For example, if you open the aperture on your camera by one stop, then the power output
levelonyourremoteashwilldecreasebyonestop.
There are two ways to engage Automatic PowerTracking:
No AC3 ZoneController on your ControlTL transmitter - Set the PowerTracking mode in the PocketWizard Utility
to a setting other than Full Manual for Automatic PowerTracking using just your camera’s controls.
AC3 ZoneController Auto Mode - Add an AC3 ZoneController set to A (Auto) on your ControlTL transmitter to
adjust power output level independently for up to 3 zones of light in conjunction with Automatic PowerTracking.
See those sections, as well as the PocketWizard Utility section, for more information.
AC3 ZoneController Manual Mode – With an AC3 ZoneController on your ControlTL transmitter, you can
havesimpleanddirectcontroloveryourashoutputpower.SeethesectiononUsing an AC3 ZoneController
for more information.
& PowerTracking