Quick start Guide

PowerTracking Tab
PowerTracking Control: AdjustshowControlTL-capableremotestudioashes,likeashesconnectedtoa
PowerMC2, respond to the AC3 ZoneController in Auto Mode, or to a ControlTL Transmitter with no AC3. See the
ControlTL & PowerTracking section for information.
Full Manual (default): Turns off PowerTracking for aperture and ISO. See the Basic Power Control section
for more information.
Nikon: WithnoAC3ZoneControlleronthetransmitter,onlythecamera’sFEC/ECcontrolwilladjustash 
power output level.
Canon: WithnoAC3ZoneControlleronthetransmitter,thecamera’sISOandFECcontrolswilladjustash
power output level.
With an AC3 ZoneController on the transmitter, any zones set to Auto Mode will operate as Center on ISO
& Aperture with First Shot (see below) when this control is set to Full Manual. AC3 Manual Mode
 canbeusedtoadjustashoutputpowermanuallywithanAC3.
Center on ISO & Aperture with First Shot: ApertureandISOassetonthecamerafortherstexposure 
 willbealignedwiththeControlTLcenterpoint(3stopsdownfromyourash’smaximumoutputpower).For 
 exampleifyourcameraissettoISO100andF:5.6foritsrstexposure,thenthoseexposuresettingswillyield
 aashoutputpowerof1/8.Adjustmentstoaperture,ISO,andFECwilladjustashoutputpoweraccordingly,
as will adjusting the Power Dial on AC3 zone in Auto Mode. See the Automatic PowerTracking section
for more information.
Center on ISO & Aperture: Lets you set the aperture and ISO that will be aligned with the ControlTL center
 point(3stopsdownfromyourash’smaximumoutputpower).Adjustthedrop-downboxesfortheAperture 
Center-On and ISO Center-On values you want to use.