Quick start Guide

FlexTT5 or MiniTT1 Transmitter settings that affect the use of a
PowerMC2:
Modeling Tab
Modeling Light Control: Check this box to control modeling light behavior from the transmitter. Default = Enabled
Control Mode: Determines when the modeling light will go to its active setting. Set to Camera Wake to have the
modeling light go active when the camera’s shutter release is half-pressed. Set to AF-Assist to have the modeling light
go active only when the camera requests auto-focus assist. Default = Camera Wake
Modeling Light Autotrack: Enable this control for the modeling light level to track with the camera exposure
or AC3 Power Dial settings. Default = Enabled
Modeling Light Active XX%: Sets the active output level of the modeling light if Autotrack is not used.
Default = 100%
Modeling Light Sleep: Check this box to have the modeling light automatically go to a set output level after
a set time. If this box is unchecked, the modeling light will never sleep. Default = Enabled
Modeling Light Sleep XX%: Sets the output level of the modeling light when it sleeps. Default = 10%
Modeling Light Delay After Camera Sleeps: Sets the number of seconds after the camera sleeps (meters go
inactive) when the modeling light will go to its sleep value. Default = 30 seconds