Quick start Guide

PocketWizard Utility
Some settings require the PocketWizard Utility software and your ControlTL radio
connected to a computer via the Mini-USB port. Download the Utility at:
www.PocketWizard.com/support
WARNING: To avoid electrical damage, never connect the PowerMC2 to a USB while it is installed in the Einstein
™
E640Flash.AlwaysremovetheradiomodulefromtheashpackbeforeconnectingittotheUSB.
PowerMC2 Receiver Utility settings:
Exposure Tab
Flash Exposure Compensation (FEC):Offsetsexposurefortheconnectedashonly.Thissettingcanbeused
asasimpleFECcontrolforanindividualash,oritcanbeusedtosetashesonthesamezonetodifferentpower
outputs or to balance them. This setting is cumulative with other FEC values set in the system. This control can also
be used to adjust where the PowerTracking center point aligns with your camera’s FEC control. See the FEC NOTE and
Camera FEC Range section for more information. Default = 0.0
Sleep Tab
Modeling Light Sleep: The modeling light will turn off after the set time if no triggers are received. Uncheck the box to
have the modeling light stay on. Default = Enabled at 600 seconds (10 minutes)
Hibernate: When an Einstein
™
E640 Flash is turned off, it’s actually in STANDBY Mode and can be turned on remotely
via a ControlTL radio. Uncheck the box to have the E640 never automatically power off.
Default = Enabled at 60 minutes
IMPORTANT: Make sure to press the Set Conguration button to save your settings.