Quick start Guide

Remote ash with or without CLS / i-TTL ash on camera

1. Slide MiniTT1

Transmitter or FlexTT5

Transceiver onto camera.

2. If desired, slide Nikon SB800 or SB900 Speedlight onto camera-mounted MiniTT1 or

FlexTT5 radio and set it to MASTER mode.

3. Attach ControlTL or standard PocketWizard

radio to studio ash.

4. Make sure all your PocketWizard radios are on the same channel and take pictures normally.

Note: Manual remote ashes are not calculated as part of the i-TTL exposure. For proper

exposure, adjust your camera’s exposure settings, or adjust the power level directly on your

remote ash.

Use PocketWizard Utility to engage HyperSync

™

and explore faster than X-sync shutter

speeds. Visit PocketWizard.com/support/downloads for more information.

Learn about the AC3 ZoneController, PowerTracking, and controlling your Speedlights and

select studio ashes by reading the extended documentation found at:

wiki.PocketWizard.com

Manual Flash

PocketWizard Accessories

English

Studio Flash, etc.

• AC3 ZoneController for Nikon • Motor Drive cables for Remote Camera Triggering

• AC9 AlienBees Adapter for Nikon • Sync cables for studio ash triggering using the

• PowerST4 for Elinchrom RX P2 Remote Flash Triggering Port

• PowerMC2 for Einstein

™

E640 For more accessories, visit PocketWizard.com.