Specifications

a
Advanced Wireless CLS / i-TTL: MiniTT1 FlexTT5
Flash on Camera
1. Slide MiniTT1 Transmitter onto camera.
2. Slide Nikon SB-800 or SB-900 Speedlight onto MiniTT1 radio. Set Speedlight for
MASTER = ON. Enable remote groups/zones per ash instructions. Nikon SU-800
Wireless Speedlight Commander may also be used.
3. Set remote FlexTT5 radio to desired remote group/zone (A, B, C) using
FlexTT5 zone switch.
4. Slide Speedlight onto remote FlexTT5 Transceiver. Set Speedlight for standard i-TTL mode
(not REMOTE or MASTER). Repeat for each remote Speedlight. All remote i-TTL
Speedlights on the same group/zone will be treated as one zone of light.
5. Adjust ash output level compensation using MASTER Speedlight ash controls.
6. Make sure all your PocketWizard radios are on the same channel and take pictures normally.
IMPORTANT: Nikon Speedlights set to REMOTE = ON and connected to remote FlexTT5
radios will not function properly as remotes. You must be in normal i-TTL mode for remotes
to operate properly. Turn off REMOTE or MASTER for your remote Speedlights. Set desired
Nikon remote group/zone via remote FlexTT5 zone switch. PocketWizard channel is used
instead of Nikon channel.
ISO, aperture, ash exposure compensation (FEC), and other settings will work with exposure
normally via the PocketWizard ControlTL system.
Note: Changes made on camera will not display on back of remote ash’s LCD.
CLS / i-TTL