Owner`s manual

info@pocketwizard.com

- Depth of Field preview remote activation added. When you press the DOF preview button on your camera,

your remote ashes will activate their DOF preview mode normally.

- Remote camera pre-trigger/wakeup control from a MultiMAX Transceiver – This allows you to remotely

wake-up or sleep your remote camera when it’s connected to a FlexTT5 by simply toggling its Zone on a

transmitting MultiMAX. Requires an -ACC motor drive cable. Works in Basic Trigger Mode or when

receiving on a Quad-Triggering Standard Channel (un-check “Use ControlTL for Rx Channel” on the

Channel tab). Not available on ControlTL channels.

Bug Fixes / Renements

- Force Master Mode with a 430EX II has been improved on the Rebel XSi, and possibly other cameras,

when triggering a MiniTT1. Corrects an issue where a full power ash (blowout) would occur on occasion.

- Remote Wireless Manual Power Control will now permit maximum output power on all ashes when used

in X-Sync mode (HSS mode was not an issue).

- Corrected a situation where pressing TEST on a FlexTT5 made it so you could not trigger for 2 or 3

seconds, but only on a Standard Channel.

- Flash Exposure Lock (FEL) with 5D Mark II has been improved. Corrected a situation where pressing FEL

would cause a remote ash to trigger and/or blowouts would occur.

- Improved continuous remote camera triggering operation for the following scenario: FlexTT5 connected

to a camera’s motor drive port with an -ACC cable and set to a Standard channel and Bottom Shoe

Disable mode turned on.

- Improved 50D performance by eliminating an issue with blowouts occurring with on-camera ash set to

Master Mode or when using Force TTL Master Mode.

- Corrected 420EX ash periodic random exposure blowouts when used as remote ash on a FlexTT5.

- Improved battery monitoring for MiniTT1 Transmitter.

- Power management changes to reduce risk of battery leakage on FlexTT5 when used with alkaline

batteries. The MiniTT1 coin cell is less likely to leak based on its chemistry.

- Corrected 1D Mark III with on-camera ash which had periodic blowouts if put in 10 fps high speed drive

mode.

- Corrected a relay mode lock-up issue (camera would trigger continuously) which occurred when TEST

was pressed on the remote FlexTT5 in Basic Trigger Mode.

- Corrected possibility of random blowouts if pre-ash RF command was missed by FlexTT5.

- Fixed problems with Bottom Shoe Disable mode where bottom shoe was still responding to shoe data

which could cause a remote camera to not trigger.

- Corrected issue where Canon 1D Mark II or 1D Mark IIn would not trigger from CM-N3-ACC cord.

- Corrected issue where 430EX II would appear to switch out of SLAVE mode automatically as the FlexTT5

was turned on, but did not do so properly and would then not trigger correctly. Switching out of SLAVE

mode is the correct behavior as Canon SLAVE mode is not used for remote ControlTL ashes.