Owner`s manual

Canon Compatibility

The MiniTT1/FlexTT5 are E-TTL II compatible with these Canon cameras:

DSLR Cameras 1Ds MKIII, MKII, 1D MKIII, MKII, 1D MKII N

5D, 5D MKII

20D, 30D

, 40D, 50D

Rebel XT / 350D, Rebel XTi / 400D, Rebel XS / 1000D,

Rebel XSi / 450D

The MiniTT1/FlexTT5 are E-TTL II compatible with these Canon ﬂashes:

Flash Units 580EX, 580EX II, 430EX, 430EX II

NOTES on overall system performance (visit PocketWizard.com for the latest updates):

1. HyperSync performance varies by camera. Although all cameras listed will have some HyperSync benet,

some will not achieve 1/400 or 1/500. See PocketWizard.com for a listing of specic camera capabilities

and HyperSync settings.

2. Commonly, a normal shutter release occurs after rst pressing the shutter button halfway to establish focus

and exposure. If the camera is in sleep mode and the shutter release is pressed all the way down without rst

establishing focus and exposure, the rst exposure may not be proper.

3. Canon ash models 430EX, 580EX, and 580EX II emit RF interference that can substantially reduce the

effective operating range of many radio slaves, including the FlexTT5. For these model ashes, please utilize

the mounting suggestions on Page 30 to optimize range. Using Canon’s off shoe cord OC-E3, greatly improves

range. Consider adding a ferrite clamp on the cable near the ash to further increase range. The Canon

430EX II performs dramatically better in this regard. It does not require special mounting consideration and

yields greater range.

NOTES for specic cameras:

1. On the 5D MarkII, a ash mounted in the hot-shoe of a MiniTT1/FlexTT5 on camera will currently not function.

This should be solved with further testing.

2. When remote triggering the 30D camera, it must be set to “Auto Power Off – Disable” otherwise

once camera sleeps, trigger will not work.