Owner`s manual

Front Curtain Clipping = move HyperSync

slider towards 0

Rear Curtain Clipping = move HyperSync

slider away from 0

HyperSync

& High Speed Sync (FP Flash) (cont’d)

HyperSync is set in a transmitting radio only. It is not

used in a remote FlexTT5. All receiving PocketWizard

radios, including the Plus II, etc., will trigger in sync with

HyperSync. At 1/640 and above, Standard triggers

are not sent.

NOTE: HyperSync requires a MiniTT1 or FlexTT5 as a

transmitter. A Standard transmitter like a Plus II cannot

trigger a remote FlexTT5 and achieve HyperSync.

If you are seeing Front Curtain clipping (top of frame

is dark), then your HyperSync offset should be moved

towards 0 (zero). If you are seeing Rear Curtain clipping

(bottom of frame is dark), then your HyperSync offset

should be moved away from 0 (zero).

When making adjustments, try adjusting in 30 micro-

second steps until you see some changes, then try

smaller steps to ne tune your setting. Remember to

press Set Both Conﬁgs in the Utility after every

adjustment.

For some camera and ash combinations it is not possible

to eliminate clipping, especially at the faster HyperSync

shutter speeds like 1/400 and 1/500. Use a slower

shutter speed or use 1/640 or higher and engage

FP Flash/High Speed Sync. FP Flash/High Speed Sync

is not available on shutter speeds between 1/250 and

1/640 when using ControlTL radios.