Owner`s manual

Ratio Mode

FlexTT5 Zone A

FlexTT5 Zone B

Ratio Wireless E-TTL II: MiniTT1 OO FlexTT5

Flash on Camera

This mode uses Canon’s Wireless Flash Ratio with E-TTL II

system. Place remote ashes into different slave groups and

control the balance of light among the groups or zones.

Please read your Canon manuals for more information

on Flash Ratio with E-TTL II and how to control groups from

the master ash.

1. Slide the MiniTT1 Transmitter onto the camera and

tighten the locking ring.

2. Slide a Canon Speedlite (set for <MASTER>) onto the

MiniTT1 and secure its locking shoe. Enable slave groups

in the master Speedlite per ash manual instructions.

3. Set the remote FlexTT5 radios to the desired slave

group (A, B, C) by using the Zone Switch on the side.

Note that PocketWizard Zones are used instead of

Canon slave groups.

4. Slide the remote Speedlite onto a FlexTT5, tighten the

locking ring, and secure the FlexTT5. Repeat for each

remote Speedlite. The remote Speedlites should be set

to normal ETTL mode, not <MASTER> or <SLAVE>.

The slave group is set by the Zone Switch and not in the

remote ash. All remote E-TTL II ashes on the same Zone

will be treated as one zone of light.

5. Adjust ratios using the master Speedlite’s ash controls.

6. Trigger normally

You may use Canon’s Speedlite Transmitter, the ST-E2, instead

of a 580EX to control ratios.