Owner`s manual

[e-mail]
4
Selectable HSS Cross-over Point
UsingthePocketWizardUtility,youcanchoosetheshutterspeedatwhichHighSpeedSync(FPFlash)willstarttobeused.This
allowsyoutouseHyperSyncatshutterspeedswhereitiseffective,andthenswitchtoHSSatfastershutterspeedsandhave
seamlesshighspeedtriggeringwithallshutterspeedsusable.Onceselected,HSSwillbeusedfortheselectedshutterspeed
andallfastershutterspeedsupto1/8000.
InthePocketWizardUtilityontheSyncTimingtab,selecttheshutterspeedwhereyouwantHSStostart.Foroptimumlight
output,thisshouldbetherstshutterspeedwhereyoubegintoseeclippingintheframethatyoucannotremovebyadjusting
HyperSync.
Ifyouwantto“turnoff”HyperSynccompletelyandjustuseHSSatallfastershutterspeedsasifyouwereusingCanon’soptical
triggeringsystem,thensetthiscontroloneshutterspeedfasterthanyourcamera’sX-sync.Youwillnotreceivetheextralight
output(andworkingdistanceandbatterylife)thatHyperSyncoffers,butthenyouwillalsonotneedtoadjustHyperSync.
Thedefaultisnowsetto1/400since5Dand5DMarkIIuserswerendingthoseshutterspeedsunusableundertheprior
methodofAuto-HSScrossoverat1/640.
ADDITIONAL NOTES:
CAUTION! To ensure you do not miss the rst shot after the ash on camera sleeps, make sure to set the Custom Function for
the ash on camera to Auto Power Off Disable. This applies for all cameras, and any Speedlite used on the MiniTT1 or FlexTT5
as a transmitter. It does not apply to a Speedlite used on a FlexTT5 as a remote ash.
A MiniTT1 when used in Basic Trigger Mode must have its TEST button pressed once to trigger remote radios.
