Owner`s manual
info@pocketwizard.com
5
www.PocketWizard.com
© 2009 LPA Design, Inc. All rights reserved. Product features and specications
are subject to change without notice. PocketWizard, ControlTL, MiniTT1, FlexTT5,
HyperSync, Plus II and MultiMAX are either trademarks or registered trademarks
of LPA Design, Inc. All other trademarks contained herein are the property of their
respective owners.
This product is covered under a warranty. For more information on this warranty
and to register your product, please go to www.PocketWizard.com/support.
US Patent: 5,359,375 and Patents Pending
• Continuous triggering of a remote FlexTT5, like used for a continuous motor drive burst for a remote camera, was not work
ing in Basic Trigger Mode. Also Basic Trigger Mode, when set on a FlexTT5, would only send a single trigger when TEST was
held. This would affect both remote camera triggering and teaching a radio a new channel. This has been corrected.
• Operation with a 5D Mark II using Master Ratio Mode with a ash or ST-E2 on top has been improved.
• Errors with top shoe ash communication after camera wakeup when using a 5D Mark II have been corrected.
• Basic Trigger Mode now triggers a ash in the top shoe (and P2 for a FlexTT5) when on a camera.
• Fixed a Learn Mode bug in Basic Trigger Mode. If learn mode was engaged during Basic Trigger Mode, but no channel was
actually learned, the radio would stop transmitting the previously known channel. This has been corrected.
• 5D Mark II operation with an HSS enabled ash on the radio on the camera has been xed.
Not included in this release:
• If TEST is pressed on a FlexTT5 in the shoe of a camera, the radio will not allow a Standard trigger from the camera until the
STATUS LED blinks twice. This will be corrected in a future release.
• If TEST is pressed on a relay FlexTT5 (in the shoe of camera with motor drive cable attached to P1) while in Basic Trigger
Mode, the camera gets locked into a continuous trigger. Workaround = test the relay setup using a transmitting PW instead
of pressing TEST on the relay radio. Should be corrected in a future release.
• G9 and G10 operation no longer supported. A future release may reverse this situation.
• On a Rebel XSi, infrequently the camera will revert to 1/200 and then be unable to adjust the shutter speed higher.
• On a 20D there may be a slight delay of the local ash trigger at HSS shutter speeds.
• On a 5D (not the Mark II) with a 580EX II in the top shoe of a ControlTL radio at fastest HSS shutter speeds, a slight banding
can occur at the bottom of the frame. A possible workaround is to use Force TTL Master Mode or use slower shutter
speeds.
• On a 5D Mark II, and possibly other cameras, a low power test ash can very rarely occur when pressing other camera
buttons like FEC.
• Remote camera pre-trigger toggle via a MultiMAX on a Standard channel is not implemented at this time.
• Features not expressly covered like Rear Curtain Sync, FEB, stroboscopic, remote DOFP and modeling mode, and adjusting
ash settings or custom functions via the camera’s menu controls are not yet implemented.
• Other manufacturer’s ashes like Quantum, Metz, Sunpak, etc. compatibility is not conrmed.
• Custom IDs not yet available.