Quick start Guide

With only a MiniTT1 or FlexTT5 on your camera, your
camera’s FEC (Flash Exposure Compensation) control
willadjustyourashpoweroutputlevelforallyour
PowerMC2-connectedashesasshowninthetable
on the right.
Nikon: The camera’s FEC or EC (Exposure Compensation)
controlwilladjustashpoweroutputlevel.TheNikonD3
series cameras do not have an FEC adjustment. You can
use the EC adjustment on all Nikon cameras, including the
D3series,wheneveraashpoweroutputleveladjustment
is needed.
Canon: Both the camera’s ISO and FEC controls will adjust
ashpoweroutputlevel.ChangestoFECwilladjustash
power output level as shown in the table on the right. Changes
fromtheISOusedforyourrstpicturewilladjustashoutput
powerlevelrelativetoFEC.Forexample,ifyourrstpicture
wasatISO200,andyouadjustedISOdownto100,yourash
power level would be 1 stop brighter for all FEC settings.
This operation assumes PowerTracking is set to Full Manual in
the PocketWizard Utility which is the default.
You can use any PocketWizard receiving radios together in the
same exposure, including other ControlTL radios. Remember
thatstudioandmanualashoutputwillnotbecalculatedas
part of an E-TTL / i-TTL exposure.
Basic Power Control
Camera FEC/EC
- or -
AC3 Power Dial
in Manual
+ 3
+ 2.7
+ 2.3
+ 2
+ 1.7
+ 1.3
+ 1
+ 0.7
+ 0.3
- 0
- 0.3
- 0.7
- 1
- 1.3
- 1.7
- 2
- 2.3
- 2.7
- 3
Einstein
™
E640
Power Output
1/1
1/2 + 0.6
1/2 + 0.3
1/2
1/4 + 0.6
1/4 + 0.3
1/4
1/8 + 0.6
1/8 + 0.3
1/8
1/16 + 0.6
1/16 + 0.3
1/16
1/32 + 0.6
1/32 + 0.3
1/32
1/64 + 0.6
1/64 + 0.3
1/64