User Manual

• Code: the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(32) Scan of frequencies with CTCSS (SEEK CTC) - Menu No. 31
The function allows scanning the frequencies with CTCSS tone enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(33) Scan of frequencies with DCS (SEEK DCS) - Menu No. 32
This function allows scanning the frequencies with DCS code enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(34) Squelch tail elimination (TAIL) - Menu No. 33
This function is used eliminate squelch tail noise between handhelds that are communicating directly (no repeater).
Reception of a 55 Hz or 134.4 Hz tone burst mutes the audio long enough to prevent hearing any squelch tail noise.
(35) Squelch tail elimination of repeater (RP-STE) - Menu No. 34
This function is used when the radio operates through a repeater; when the PTT is released, the repeater will emit the end
transmission tone to confirm it is working.
Available settings:
Off, 1,2,3,4,5,….10 to set the delay time.
Note: Please disable this function in normal using, lest affect your normal conversation.
(36) Delay the squelch tail of repeater (RPT-RL) - Menu No.35
With this function you have the confirmation that the repeater has transferred the signal. You can choose amongst: Off
1,2,3,4,5,….10 to set the delay time.