User Manual

(27) Frequency offset direction (Direction) - MENU No.26
Using this function, you can set the direction of the frequency offset in rx and tx.
You have the following options:
• Plus: Positive offset;
• Minus: Negative offset;
• None: No offset.
Note: you should set different frequency deviation according to the repeaters selected. This function is not enabled in
channel mode.
(28) Frequency offset (Offset) - MENU No. 27
In this MENU you can set the deviation between tx and rx. The frequency offset of this radio is 00.000-99.998MHz.
(29) Channel store - (Memory) - MENU No. 28
When the radio is in frequency working mode or standby mode, input the desired frequency or parameters directly.
NOTES: If you want to set CTCSS tones, DCS codes or the frequency offset, you have to do it before storing the channel.
The channels already stored are displayed as CH-XXX ("CH" and -channel number), and other channels only display
channel numbers.
(30) Channel Delete (Delete) - MENU No.29
In this menu you can delete a channel of the radio.
(31) Alarm Mode (Alarm Mode) - MENU No.30
This function can set the tone alarm/code alarm/site alarm of the radio.
Keep pressed the [SK1] key for 3 seconds to start the alarm tone.
The following three options can be selected:
• Site: the speaker emits an alarm tone but the radio doesn’t transmit;
• Tone: the speaker emits an alarm tone and the radio transmits it;