Owner's Manual

4. Emergency Alert Model
This function can set the off alert/ site alert/ tone alert of the radio. Keep pressed the [LAMP] button for 3 seconds to start
the alarm tone.
To select, press the [MENU] button until a
icon appears and to the right of the icon the current Emergency
Alert Model setting is displayed. Then press the  or  buttons to make the Emergency Alert Model selections. To confirm,
press the [PTT] button or press the [MENU] button to move to the next feature setting.
NOTE: The following three options can be selected:
- OFF: means to close the alarm function;
- 1. Means local alarm, sounds alarm through your radio speaker only
- 2. Means broadcast alarm, transmits a cycling tone over-the air.
5. Keypad Silent Operation
Your radio has a keypad silent operation mode. In this mode, all “keypad beeps” and “tones” are disabled. To set the keypad
silent operation, press the [MENU] button until the display shows a “bP” icon. Select “on” or “oF” by pressing the  or 
buttons and push the [PTT] key or [MENU] button.
6. Roger Beep (end of transmission) TONE
When the [PTT] button is released, the radio will beep to confirm to other users that your transmission has finished. To turn
the ROGER BEEP tone on, press the [MENU] button until the display shows a “rb” icon while on the right of the “rb” display,
an “oF” icon appears. Select “on” by pressing the  or  buttons and push the [PTT] key, or press the [MENU] button to
move to the next feature setting. To turn the ROGER BEEP tone off, press the [MENU] button until the display shows a “rb”
icon while on the right of the “rb” display, an “on” icon appears. Select “oF” by pressing the  or  buttons and push the
[PTT] key, or press the [MENU] button to move to the next feature setting.