Installation Guide

round cut installation
round cut installation
69
2ND and Subsequent Courses on
Gable End
a.Make new template for angle if
needed.
b.Measure from the Left Side Flange
making sure to stagger the laps by at
least 3 half-rounds (Figure 28).
c.Align Left Side Flange with near-
est Alignment Line of course below
(Figure 28).
d.Insert Bottom Lock into Top
Lock of course below. Pull up tight
and nail according to “NAILING
PROCEDURES”.
e.For second and subsequent panels,
align Left Side Flange with nearest
Alignment Line of course below that
allows for proper fit.
Insert Bottom Lock into Top Lock
of course below. Pull up tight
and nail according to “NAILING
PROCEDURES.
Final Course on Gable end
a. Measure width needed at bottom
lock (see Figure 29).
b. Carefully check alignment of
Round Cuts to center full or partial
rounds as needed and cut
(see Figure 30).
c. Insert Bottom Lock of final course
into Top Lock of course below, pull
panel up tight, and nail at peak using
a color matching trim nail.
Fig.28
Fig.29
Fig.30