Installation Guide

round cut installation
round cut installation
68
Installing 1st Course
on Gable End
a. Use panel cut in step “d” above.
If installing into Siding or Starter
Strip, lock firmly, pull up tight
and nail according to “NAILING
PROCEDURES.”
b. Slide the next panel into position.
The top half of the panel, except
the Nail Hem, slides under, and the
bottom half slides over the previous
panel. The Nail Hem will be on top of
the previous panel (Figure 24).
Nail slots can be placed at angle cut
for additional nailing.
c. If this is your first course of
Round Cuts refer to chart for over lap
amount (Figure 25).
d. If this is not your first course of
Round Cuts, align Left Side Flange
with nearest Alignment Line of course
below that allows for proper
fit into right end finish trim.
e. Engage bottom lock firmly into
Siding or Starter Strip, pull up tight
and nail according to “NAILING
PROCEDURES”.
f. Install additional full panels,
repeating Steps c-e.
Last Panel on Each Course
a. Make template for angle if
needed.
b. Measure distance from correct
line on temperature gauge into the
gable end trim, less ¼˝ (see “L” on
Figure 26).
c. Measure panel from right end of
Nail Hem and cut at correct angle
(see “L” on Figure 27).
d. Engage lock into starter strip or
continuous lock of previous course,
pull up tight and nail according to
“NAILING PROCEDURES.”
Fig.25
Fig.26
Fig.27
Fig.24