Data Sheet

biosignalsplux
User Manual
!
!
!
75!of!159!
!
sensor type to DIA (click on the arrow in the channel’s field that appears when you hover
over the channel’s field and select DIA from the dropdown menu). Select the channel of
your systolic signal channel and set the sensor type to SYS
5
.
Activate both channels for signal acquisition by clicking on the circle in the channel field
(must be blue).
How to use your sensor
This sensor is designed to measure blood pressure levels at the wrist. Place the sensor at
the wrist of the user (ideally the left wrist) such that both the sensor’s display and the
hand palm are facing towards the user. Please do also check the instructions provided on
the cuff to ensure optimal acquisition results.
Signal acquisitions in OpenSignals (r)evolution are done by initializing the signal
acquisition in OpenSignals and pressing the On/off button on your sensor. The cuff will
start to fill itself with air and the sensor will conduct the blood pressure measurment.
If configured correctly, your acquired signals should be similar to the signal displayed in
Figure 63. Note that the sensor will achieve different states during the measurement
which can be seen in the acquires signal:
A. Sensor is not turned on but not conducting a measurement
B. Sensor cuff is being filled with air; ongoing blood pressure measurement
C. Sensor results for diastolic and systolic blood pressure values
Figure 63: Blood pressure reader sample.
5
The sensor types SYS (systolic) and DIA (diastolic) are only supported by OpenSignals (r)evolution versions
of 30.01.2018 or newer.