Data Sheet

biosignalsplux
User Manual
!
!
!
25!of!159!
!
2.4 General Device Functionality
2.4.1 Turning on the Device
In order for the device to work, it must be turned on. Turning on the device can be done
by pressing the button in the center of the biosignalsplux hub. After being turned on, the
LED status light will blink once per second (green).
Figure 10: biosignalsplux center button.
2.4.2 Connecting the Sensors
Sensors have to be connected to channel 1 to 4 or 1 to 8 (number of channels depends
on each biosignalsplux hub) in order to work properly. Do not connect the sensors to the
digital or common ground port, unless it is stated otherwise in the sensor datasheet or in
the 3 biosignalsplux Sensors chapter. The reference electrode/ground cable should be
connected to the common ground port (see Figure 6 or Figure 11).
When connecting the sensors, pay attention to where the cables go to avoid device
damages or disrupting the user’s movements.
Figure 11: biosignalsplux side view.
2.4.3 Disconnecting the Sensors
Disconnect the sensors according to the recommendations displayed below, to avoid
damaging the biosignalsplux device or the sensors:
• don’t twist the sensor while disconnecting
• don’t apply upward force or pull the cable
• use minimal force to disconnect
• hold the plug firmly and pull it out
• don’t pull the cable
Reference
Channel 1 to 4