Manualshelf

Data Sheet

ManualsBrandsPLUX ManualsBiometric SensorsBiosignalsplux Professional Research Kit (8 Sensors)
150151152153154155156157158159
biosignalsplux
User Manual
!
!
!
151!of!159!
!
11 Safety & Maintenance
Please read the following safety instructions before using your biosignalsplux system to
prevent any damages or problems with the user, test persons and/or biosignalsplux
devices. Violations of these instructions can lead to inferior signal quality and/or damages
to the biosignalsplux system and user.
!
The user should always keep the device and its accessories dry.
!
The user must turn off the biosignalsplux device and contact Technical Support if
the system or accessories reach uncomfortable temperatures.
!
The user should not use the biosignalsplux device in noisy environments
(environments with microwaves and other similar equipment). Doing so will lead
to noise increase in the acquired signals and Bluetooth connectivity issues.
!
The user must not use the device near the fire or in potentially explosive
atmospheres, such as atmospheres with flammable gas.
!
The user should only use the detection surfaces or other approved accessories
purchased from PLUX or by a PLUX agent.
!
The user should inspect the sensors on a regular basis to ensure that they remain
in good working order.
!
The user should stop using the biosignalsplux device if experience any kind of
discomfort or skin irritation.
!
The user should not use the biosignalsplux device continuously for periods of time
above 60 minutes. Do not use the system on persons with allergies to silver.
!
The user should dispose detection surfaces after using the biosignalsplux device.
Detection sur- faces are single-user and disposable. Reusable electrodes should be
reused by the same user. Do not use reusable electrodes on several users.
!
The user must not place the device in the microwave.
!
The user must not insert objects into the holes of the device.
!
The user should not open the biosignalsplux device or its accessories. The repair of
the same should be only done by properly authorized PLUX personnel.
!
The user should make sure the cables do not obstruct the passage of people.