Data Sheet

biosignalsplux
User Manual
!
!
!
26!of!159!
!
2.4.4 Charging
WARNING
Do not use the biosignalsplux device during the charging process.
biosignalsplux has a battery lifetime of up to 12 hours in continuous usage. Note, that the
lifetime might vary depending on the number of active sensors and/or accessories. The
built-in LED will light up red if the battery is running low until the device stops working.
To recharge, connect the biosignalsplux charger to the device’s charging port and to a
power outlet (see Figure 12). The charging process will take approximately 2 ½ hours to
fully charge the battery. The button will light red while charging (steady light when
turned off, and flashing red when acquiring or in stand by state), and the red color will
turn off once the battery is fully charged.
Figure 12: Charging port.
The suitable room temperature when charging the device must be between 10°C and
35°C to prevent device or user related damages during the charging process.
WARNING
Unplug the charger from the wall outlet if the battery/device overheats (reaching 60°C)
and immediately get in contact with PLUX’s Technical Assistance.
NOTE
The red LED will be switched on if an error occurs during the charging process.
In this case, unplug the charger from the wall outlet and plug it in again to complete
the charging process correctly. Please get in contact with our support if the error
remains permanently.
Charging Port