User Manual

BITalino (r)evolution
User Manual
25 of 30
Use only the detection surfaces (electrodes) provided on the
packaging of the system or acquired from PLUX or a PLUX agent.
The detection surfaces (electrodes) are disposable and intended
for single use and single user only.
Inspect the BITalino (r)evolution Board before each use to ensure
that the device is safe to use.
If you experience any kind of discomfort or skin irritation when
using the BITalino (r)evolution Board
Do not place the device in the microwave.
If the BITalino (r)evolution Board or any accessories reach
uncomfortable temperatures, turn of the device immediately and
contact PLUX’s Technical Support via e-mail ([e-mail])
or telephone [phone])
Do not insert objects into the holes of the device, it may affect the
operating characteristics and safety.
Do not open the BITalino (r)evolution Board device or any of its
accessories. Any repairing of the device must only be done by
properly trained and authorized PLUX personnel.
During the charging process, place the device and the charging
equipment so that the cable is free, away from places where it can
be walked on or damaged. Make sure the cable does not obstruct
the passage of people.
Use the charging cable with extreme caution to avoid risk of
strangulation.
The BITalino (r)evolution Board device may suffer or cause
interference to other equipment with radio receiver/transmitters,
even those that comply with international standards and
regulations. Keep a safe distance between the BITalino
(r)evolution Board and other devices to ensure their proper
function.
The BITalino (r)evolution Board should not be used in noisy
environments in relation to RF radiation which can cause
communication failure.
If your BITalino (r)evolution Board device stops working, please
contact PLUX’s Technical Support via e-mail ([e-mail])
or telephone [phone]) and stop using it until any further
notice from PLUX’s Technical Support.