Datasheet

1. Check "Event Enabled" option to enable “Motion Detection” function

in "Respond to trigger" section..

2. Check “Event Enabled” to enable the external input port in “Trigger by”

section.

3. Check the options from the drag down menu in the blank beside the “ Port

is “ section.

Information

• “Active”---input port, “Normal State” and “Current

State” are the same in “I/O Ports” section.

• “Inactive” --- input port, “Normal State” and “Current

State” are different.

4. Check option(s) in “Trigger by” section.

Information

• When “Motion Detection 1” is selected, a red square

frame appears within the viewer.

• When “Motion Detection 2” is selected, a green

square frame appears within the viewer.

• If you have connected any external sensor or device

to the network camera, “output” enables the

network camera to send alarm signal to the external

sensor or device. Please refer to “

External I/O

Interface” section.

• “Manual Trigger” is equal to the function of the

option “5V” in the input section. Even without the

5V, the alarm system can work only if you check the

option “Manual Trigger”. And when “Manual Trigger”

is enabled, never forget to check ”Activate Output 1

port” in the “When Triggered “ section and select the

option “Actinact” in the “Output Buttons” section.