Instructions / Assembly

7. On the north baseline, from the east singles sideline, measure 17 ft. 11 in. and 18 ft. 1 in. and mark both
points. These marks create both sides of the 6-in. hash mark that indicates the center of the baseline for
servers. Snap chalk lines perpendicular toward the net to create this mark.
8. From the baseline measure 18 ft. along the east side singles court sideline toward the net center line. Make
a mark and repeat on the west side of the court. Connect the two points across the court; this is the service
line.
9. From the east singles court sideline measure 13 ft. 5 in. along the service line toward the middle of the
court. Make a mark, then measure 13 ft. 7 in. from the same point toward the middle and make a mark. This
2-in. difference will become the width of the center line dividing the two service boxes. Make the same
measurements along the net center line (net location) and connect each to the service line. Half of the court
is now ready to be taped and striped.
Repeat the entire process on the south side of the court.
Note: Double check measurements and step back for a good look before applying paint. For tape we
recommend using 1” 3M old fashioned beige masking tape. Apply paint with a paint brush. We recommend two
coats of paint. For more information contact us at [e-mail], or call 888-711-7483.