User's Manual

Model 2112 Modular Tag Manual
Page 12 of 16
15.212 (a) (1) (v)
REQUIREMENT:
“The modular transmitter must be tested in a stand-alone configuration, i.e., the module must not be
inside another device during testing for compliance with part 15 requirements. Unless the transmitter module
will be battery powered, it must comply with the AC line conducted requirements found in §15.207. AC or DC
power lines and data input/output lines connected to the module must not contain ferrites, unless they will be
marketed with the module (see §15.27(a)).”
IMPLEMENTATION:
The 2112 Modular Tag was tested at the compliance test facility in the stand-alone configuration as
defined above. It was powered by a 3 volt coin cell battery and connected directly to the module with no wire
leads or ferrites.
15.212 (a) (1) (vi)
REQUIREMENT:
“The modular transmitter must be equipped with either a permanently affixed label or must be capable
of electronically displaying its FCC identification number.”
IMPLEMENTATION:
The 2112 Tag PWB will contain the FCC identification number of the 2112 Module in the silkscreen. See
IDENTIFICATION section of this document.
15.212 (a) (1) (vi) (A)
REQUIREMENT:
“If the FCC identification number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:
XYZMODEL1” or “Contains FCC ID: XYZMODEL1.” Any similar wording that expresses the same meaning may
be used.”
IMPLEMENTATION:
The final product which contains the 2112 Module will be labeled or marked to indicate that it contains
FCC ID ZEH0116. Refer to PLUS drawing 320-0315 for recommended format.
Formatted: Space Before: 6 pt, After: 6 pt