Use and Care Manual

11
3. SALT LEVEL
The control will display:
• Press the UP or DOWN ARROW to select Low, Medium, or High. Medium is a good setting for most
circumstances. For small families and low hardness, Low will provide greater salt efficiency. For large
families and high hardness, High will provide the most capacity.
Press the SCOLL BUTTON to advance to the next setting.
4. SERVICE PHONE NUMBER
The control will display:
If you do not want to change the phone number, leave this setting at NO. Press SCROLL to advance to
the next setting.
To change the number, select YES; Press the UP or DOWN ARROW and then enter the service phone
number. You may want to enter the Plumber’s Direct number 800-811-3504 or the number of a local
service provider who assisted you. Press Scroll to advance through the digits. After setting the number,
press SCROLL to advance to the next setting.
5. TIME OF DAY
The control will display:
• Press the UP or DOWN ARROW to program the time of day.
Press SCROLL BUTTON to advance to the next setting
The control will display:
If you want to go to advanced setting, press the UP or DOWN ARROW, change to YES and press the
scroll button. (see ADVANCED MENU on page 12)
If you do not want to access advance setting, leave this at NO. Press Scroll to advance to Exit screen.
Press the DOWN ARROW to exit the Installer’s Level.
Note: If you need to recheck settings or make a change, pressing SCROLL when “EXIT” is
displayed will take you back to the start of Installer Settings.
IMPORTANT NOTE: TO ACTIVATE THE NEW SETTINGS, YOU MUST EXECUTE A COMPLETE
REGENERATION. IF YOU DO NOT MANUALLY REGENERATE THE SYSTEM, THE SETTINGS WILL
NOT BECOME ACTIVE UNTIL THE UNIT HAS COMPLETED THE NEXT SCHEDULED REGENERA-
TION.
Salt Level: Med
Change Phone? No
000-000-0000
Set Time of Day
To Exit Press Down Arrow
Go to ADVANCED menu? No