Instructions / Assembly

THE ORDER NUMBER FOR THE REBED KIT INCLUDING GRAVEL IS 38923*
PRE-INSTALLATION INSTRUCTIONS
• Do not install this system where water is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• This system must be installed in an area that is not affected by extreme heat, cold or the elements.
The selected installation area must be adequate for easy service of all parts.
• This system must be installed in accordance with all applicable state and local laws and regulations.
• This system is designed to treat cold water only and can be installed on any cold water supply.
ANNUAL MAINTENANCE REQUIREMENTS
• Clean the backwash flow control.
• Verify that the flow meter is functioning correctly. Clean the impeller, if necessary.
• Verify the programming of the control. Reprogram, if necessary.
• Verify the minimum and maximum water pressure. Install a pressure reducer, if necessary.
Additional Annual Maintenance Requirement For Acid Neutralizers:
• Check the height of the filter bed by measuring the distance from the top of the tank to the top
of the filter media. Add neutralizing media as needed to reach the desired height. It is normal
for the media to be consumed as part of the neutralizing process. Depending on pH of
incoming water and usage, you may need to add media more or less frequently.
5
PRODUCT NAME PART NUMBER
MEDIA
AMOUNT
TANK
( DIAMETER X HEIGHT)
SERVICE FLOW
RATE
DRAIN FLOW
RATE
Acid Neutralizer 1.0 35596 1.0 cuft 10 X 44 6.0 gpm 6.0 gpm
Table 1 -- Filter Data Chart
Product Name Replacement Media Order Number
Acid Neutralizer Calcium Carbonate (90lbs./cu.ft) 14829
A
Table 2 -- Order Number for the replacement media
Neutralizer
TANK SIZE
Dimension “A”
when full ( inch )
10 X 44 15 ~ 17