Installation Instructions

For Models: 678-4380
Shower head
TOOLS NEEDED FOR INSALLATION: : Read instructions before installation!
Depending on your installation, you may require the following supplies:
Wrench or pliers, rags, pipe compound or tape, shower arm and flange
(if existing shower arm has ball at the end.) When using wrench or pliers,
always protect finishes by wrapping parts with a cloth.
INSTALLATION:
1. Remove old sher head from shower arm. If old shower arm has a ball
where shower head connects to arm, replace with shower arm with
threads on both ends. Clean threads on the shower arm with steel wool.
2. Apply thread seal tape to threads.
3. Install new shower head and hand tighten. Wrap a cloth around
showerhead to protect finish. Wrench tighten.
CAUTION: When using the mist spray, there is a tendency to turn temperature up
on the water. Before changing to a different spray, make sure to turn the temperature
back down.
flange
shower arm
old shower head (remove)
thread seal tape
applied to all hreads
washer
shower head
Have an installation question? DO NOT RETURN THIS PRODUCT TO THE
STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST