Installation Instructions

TOOLS NEEDED FOR INSTALLATION: Read instructions thoroughly before

installation! This installation requires the following supplies: Wrench or

pliers, steel wool, rags, pipe compound or thread seal tape, shower arm and

flange (if existing shower arm has ball at the end.) When using wrench or

pliers, always protect finishes by wrapping parts with a cloth.

Follow steps below, as required for your installation:

1. Remove old shower head from shower arm. Clean threads with steel

wool. If old shower arm has a ball where shower head connects to arm,

replace with shower arm with threads on both ends.

2. Apply pipe compound or thread seal tape to shower arm threads. Screw

diverter valve onto shower arm. Tighten firmly.

3. Using pipe compound or thread seal tape on threads, reinstall shower

head.

4. Connect hose to outlet on bottom of diverter.

Installation

Three-Way Diverter and Mount

Have an installation question? DO NOT RETURN THIS PRODUCT TO THE

STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST

For Models: 678-4363, 678-4364 &

678-4369

PAGE 1
Installation For Models: 678-4363, 678-4364 & 678-4369 Three-Way Diverter and Mount TOOLS NEEDED FOR INSTALLATION: Read instructions thoroughly before installation! This installation requires the following supplies: Wrench or pliers, steel wool, rags, pipe compound or thread seal tape, shower arm and flange (if existing shower arm has ball at the end.) When using wrench or pliers, always protect finishes by wrapping parts with a cloth. Follow steps below, as required for your installation: 1.