Installation Instructions

TOOLS NEEDED FOR INSTALLATION: Read instructions thoroughly before

installation! This installation requires the following supplies: Wrench or

pliers, rags, thread seal tape. When using wrench or pliers, always protect

finishes by wrapping parts with a cloth.

1. Remove old flange, using screwdriver to carefully pry away from wall.

2. Remove old arm by turning counter-clockwise with wrench.

3. Slide new flange onto arm. Wrap threads on one end of arm with thread

seal tape in a clockwise direction.

4. Screw taped end of arm into plumbing connection inside wall.

Hand tighten.

5. Wrap arm with cloth to protect finish and wrench tighten.

6. Push flange against wall. Wrap threads of shower arm with tape, as

explained above. Install new showerhead and hand tighten. Wrap a cloth

around showerhead to protect finish and wrench tighten.

Installation

Shower Arm & Flange

Have an installation question? DO NOT RETURN THIS PRODUCT TO THE

STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST

For Models: 678-4370, 678-4372 and

678-4377

PAGE 1
Installation For Models: 678-4370, 678-4372 and 678-4377 Shower Arm & Flange TOOLS NEEDED FOR INSTALLATION: Read instructions thoroughly before installation! This installation requires the following supplies: Wrench or pliers, rags, thread seal tape. When using wrench or pliers, always protect finishes by wrapping parts with a cloth. 1. Remove old flange, using screwdriver to carefully pry away from wall. 2. Remove old arm by turning counter-clockwise with wrench. 3. Slide new flange onto arm.