Installation Instructions

20. After the pop-up drain has been checked for leaks, empty the
sink. Run hot and cold water uninterrupted for about one minute
to remove any residue from the lines. Replace and tighten the
aerator.
Assembly (Steps 16-20)
Have an installation question? DO NOT RETURN THIS PRODUCT TO THE
STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST
6.
16. With the pivot rod (20) in the down position, guide the pivot rod
through the nearest hole on the lift rod strap (23). Make sure that
the pivot rod remains in the down position. Once it is aligned
properly, tighten the set screw on the lift rod strap.
17. Secure the pivot rod (20) onto the lift rod strap (23) with the
spring clip (22). Adjust the height of the pop-up rod by adjusting
the set screw (21) and raising or lowering the lift rod strap (23).
20
23
18. Before turning the water on, unscrew and remove the aerator (13)
from the faucet spout. If necessary, use pliers and a cloth to
protect the finish of the faucet.
16
8
18
20
22
23
21
17
19
19. Open the hot and cold water supply valves. Check for leaks at
the shut off valves and the faucet shanks. If leaks occur, tighten
the nuts on the water supply lines and shut off valve. Fill the sink
with water to check for leaks. If water is leaking from the drain,
tighten the mounting nut (17) on the drain body (16).