Installation Instructions

15. Place the pop-up rod (14) through hole in the faucet and guide it

through the holes on the lift rod strap (23). Lightly tighten the set

screw (21) on the lift rod strap (see figure D).

NOTE: Be sure that there is enough room to lift the pop-up rod

up and down to open and close the plunger.

Assembly (Steps 11-15)

Have an installation question? DO NOT RETURN THIS PRODUCT TO THE

STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST

14. Slide the pivot rod nut (19) onto the pivot rod (20) and thread the

pivot nut onto the drain body (see figure C). Tighten firmly but do

not overtighten.

11. From underneath the sink, tighten the mounting nut (17) until the

rubber gasket seals securely to the bottom of the sink. Make

sure that the drain seat (18) is sitting straight. When tightening,

hold the drain body so that the threaded pivot rod opening is

facing ther back of the sink.

12. Insert the plunger (24) into the drain seat (18). Make sure that the

hole at the bottom is facing the back of the sink

13. Place the pivot rod (20) into the opening in the drain body (16),

making sure that the rod enters the opening at the bottom of

the plunger (24, see figure A). NOTE: Make sure that the pivot

rod seal (25) is seated inside the drain body (16, see figure B).

threaded

pivot rod

opening

gure A

gure C

gure D

pivot rod seal

gure B