Installation Instructions

10
10. From underneath the sink, insert the threaded end of the drain
body (16) through the drain opening in the sink and screw the
drain seat (18) back onto the drain body (16). NOTE: Be sure to
have the mounting nut and rubber gasket (17) on the drain body
before inserting it into the drain hole.
Assembly (Steps 6-10)
Have an installation question? DO NOT RETURN THIS PRODUCT TO THE
STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST
4.
9
8
9. Apply a bead of silicone sealant to the underside of the drain
seat flange (18).
7. Remove old pop-up drain assembly. Clean all sink surfaces to
remove old putty and dirt before installing the new drain
assembly. Please check the drain body (16) and drain seat (18)
for any damage prior to installation. If there is no damage, please
install as directed. If any damage occurs please call Customer
Service for a replacement before installing. Disassemble the new
pop-up assembly.
7
17
22
23
16
18
24
20
19
21
25
8. Remove the drain seat (18) and the pop-up plunger (24) from the
pop-up assembly. Turn the mounting nut (17) down towards the
center of the drain body (16).
18
16
17
16
18
17
6
6. Apply thread seal tape onto the threads of the water supply shut
off valves in a clockwise motion. Attach the remaining ends of the
water supply lines to the hot and cold shut-off valves and tighten
with a wrench.