Installation Instructions

Assembly (Steps 12-16)
Have an installation question? DO NOT RETURN THIS PRODUCT TO THE
STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST
5.
13. Apply thread seal tape onto the threads of the water supply shut
off valves in a clockwise motion. Attach the remaining ends of the
water supply lines to the hot and cold shut-off valves and tighten
with a wrench.
12. Attach one end of the water supply lines onto the faucet
shanks, hot water on the left and cold water on the right. (NOTE:
If you are installing new water supply lines, please refer to the
supply line manufacturer’s installation instructions.) Tighten the
supply line connections using an adjustable or basin wrench.
12
13
16. Run hot and cold water uninterrupted for about one minute
to remove any residue from the lines. Replace and tighten the
aerator.
14. Before turning the water on, unscrew and remove the aerator (15)
from the faucet spout. If necessary, use pliers and a cloth to
protect the finish of the faucet.
8
14
15
15. Open the hot and cold water supply valves. Check for leaks at
the shut off valves, faucet shanks, and sprayer house connection.
If leaks occur, tighten the nuts on the appropriate connection.