Installation Instructions

1. Shut off the water supply from the stop valves by turning the

handle clockwise and remove the existing faucet from the sink.

Preparation/Assembly (Steps 1-5)

Have an installation question? DO NOT RETURN THIS PRODUCT TO THE

STORE. Call toll free: 1-800-545-5230 Monday thru Friday 8:00am - 5:00pm CST

3. Apply a thin bead of silicone sealant to the underside of the

attached deck plate (16) and carefully slide the faucet shanks

into the sink holes and position the faucet into the desired area.

4. Thread the plastic wing nuts (17) onto the faucet shanks and

hand tighten. NOTE: It is helpful to have a second person hold

the faucet in place while tightening the wing nuts (17).

PLEASE NOTE: Do not remove the customer service tag with

the model number and phone number as this will be helpful if

you need assistance in the future.

2. Remove any dirt or plumber’s putty from around the faucet

holes on the sink.

5. Apply thread seal tape to the faucet shanks in a clockwise

motion. Attach one end of the water supply lines onto the faucet

shanks, hot water on the left and cold water on the right. (NOTE:

If you are installing new water supply lines, please refer to the

supply line manufacturer’s installation instructions.) Tighten the

supply line connections using an adjustable or basin wrench.